Manual License Activation (Neurotec Biometric 4.5 or later Activation Wizard)
Posted by on 12 February 2015 10:34 AM
Generate computer id file
Save the Serial Number license in a text file in the same location as the Activation Wizard (For this example the Serial Number license is saved in a file titled “sn.txt”) Note: when saving the serial number to a text file, only add the actually serial number, not the name of the license: XXXX-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX-XXXX
Open a command prompt and go to the location of the Activation Wizard
Run id_gen.exe with parameters: id_gen.exe serial_number_file id_file
Example: id_gen.exe sn.txt Neurotechnology.id
*sn.txt is the file with the Serial Number in it
Generates computer file Neurotechnology.id.
*Once the file is generated, leave the command prompt open (You will need this location again on the last step)
Obtain license file
Transfer the file you saved (Neurotechnology.id) to a computer that has internet access.
Go to: http://www.neurotechnology.com/cgi-bin/nla.cgi and upload the file (Input a valid email address)
Save the received license file (*.lic) to the same location as the Activation Wizard and pg.exe
Starting Neurotechnology service
In the command prompt (in the location of the Activation Wizard) run command: pg.exe –install